Dillard Racing: The Boat

Jerry Jensen and Steve hold the boat while Brent prepares for weigh in.

Brief Overview:

16 foot boat made of marine plywood and carbon fiber
56 cubic inch Evinrude 3 cylinder gas engine. Full throttle operation between 8,000 and 8,500 RPM. Dynos over 100 horsepower.
Boat and motor weighs over 825 pounds
23 or 24 inch pitch propellers
Average speed 79-80mph
Top speed 85mph
Full air system
5-strap, 4 point central release mechanism seatbelt
Trim indicator
AFM computer system providing technical support data
Electrical engine stop switch
Helmet equipped with radio system
2 three inch unrestricted area vents on the pickleforks
Reinforced cockpit
Internal and external release capability canopy with stainless steel hinge pins

Brent and John Wienandt at post race engine teardown
at the National Championships

Steve, Brent and Robbie inspect the lower unit	Brent services engine after Division Championship
2011 New Boat Class Construction New Frame Ribs for Pontoons
Close up of frame ribs for pontoons
Center Beam now installed
Framework for support	Bottom Deck installed
Seams filled
Veiw of top side- upside down	Side view
Fiber glass complete
Steve & Brent making adjustments	Outside on the trailer
Steve ordering parts
Outside - Side view	The beast emerges from the cave
Proud moment for Brent
Narrow Escape	Brute Force
Ready For The Road. Let get an engine on me, I am ready to race.

2011 New Boat Class Construction